Vibra-Tite VC-3
+3

Vibra-Tite VC-3

00068
£1.50
In stock
1
Product Details

Quiver Killer only recommend the use Vibra-tite VC-3 to secure the M5 mounting screws into the Quiver Killer inserts. VC3 is a non-anaerobic formula that is benign to all plastics.

One sachet is sufficient for one set of binding screws plus a few spares.

VC3 Application reduced

Simply coat the end 4/5mm of the mounting screws in the VC3 solution & leave to completely dry (approx 5 mins) before installation. The screws can then be kept in a bag in your tool kit when travelling etc. The screws may be un- and re-installed several times without reapplication. Don’t be concerned when you first remove the screws and it appears that there’s not much of the VC3 on the threads as it will now be in the insert.

There’s a couple of methods that work best for coating the threads:

1. Cut off the corner of the sachet at 45 degrees to leave a hole just big enough for the mounting screw to go through then simply poke the screw in to the sachet in to the solution. Then stand thread up/head down to dry.

2. Pour the solution in to a small dish then dip the screw in. Then stand thread up/head down to dry.

Whichever method you use you’ll need to work quickly as the solution starts to go ‘off’ after about 5 minutes.

IMPORTANT NOTICE REGARDING THE USE OF LOCTITE:
Loctite may be harmful to some of the plastics of which bindings are composed. For example, 22 Designs specifically forbids the use of Loctite with their telemark bindings. I have personally witnessed binding base plates fracture after contact with Loctite so please only use VC3 to secure your insert mounting screws.
Save this product for later
Display prices in: GBP